0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What size gas tank does a 2006 Buick rendezvous have?
18 gallons (approx.) per Buick
What is the correct tire size for a 2006 Buick Rendezvous?
225/60/17 seems to be the commonly accepted size.
What size is the oil drain bolt on 2002 buick rendezvous?
Im the one who asked the question
What size of wheels are on 2003 buick rendezvous?
get a tape or look at your tire ,the last # is your wheel side in inch
What is the size of the front wheel hub nut on a 2002 Buick Rendezvous?
34 mm (or 1 5/16")
What is the biggest size rims you can put on a 02' Buick Rendezvous?
A tire shop will be the best one to answer there are many aspects offset, tire size etc
What year was the Buick Rendevous introduced?
Buick Rendezvous is a car, introduced in the spring of 2001 as a 2002 model year vehicle. The car was a mid-size luxury crossover SUV and was sold by the Buick division of General.
What size is the front wheel hub nut on a 2002 Buick Rendezvous?
The book states from 2002-2007, the front cv axle nut is a 34mm.
What size wrench does a brake bleeder screw take on a 1998 Chevy k 1500?
Have a good set of small wrenches ready. Bleeder screws are not always original. But almost all are 8 or 10mm or 1/4 or 5/16 . -If you work on your own vehicle these are all necessary wrenches.
If there is air in your coolant system and you were told to let the air out of the pressure valve where is this valve?
you need to find the bleeding screw that is located on or by the thermostat housing.you'l know that is a bleeding screw/valve because the bolt is not holding anything down. you'll turn it with the car off. you will see a pin size hole on it. turn on your car and when coolant start to flow out of it you have succesfully taken out the air from the cooling system. answer the coolant system bleeder is generally on water pump the bleeder looks same as a brake bleeder and works in exactly same way
What is number 8 size screw?
The next size larger from a number 6 size screw.
The hole the bleeder screw goes in is stripped how do you replace it and what do you need to fix it?
The hole will need to be drilled to a larger size, and tapped. If possible the part needs to be removed, the metal shavings that fall on the inside can get into the cooling system and cause serious damage.
