I had the same problem. This is the problem. The bushings on the lower right control arm are worn out. These are the GM (remember GM bought Daewoo) part numbers, 96308002 and 96492383. They run about $8.00 a piece. Unless you have hit something very, very hard, your control arms should be fine. A local garage/dealer can put press out the old ones and press the new ones in. That fixed the problem with mine.
AnswerMy opinion on this is that it could be the Throttle Position Sensor also called the TPS. I know this because my car did the same thing and we are having to replace this part. Good Luck! AnswerIt is a front wheel drive car, Yes?Under acceleration, one front tire is getting less grip on the roadway than the other tire is getting, and that is called "torque steer" This is quite normal, and the solution is to back off the gas pedal a bit.
The car is pulling to the right because that right side tire is getting a better grip than the left one is. Just be a little less aggressive on the gas pedal, OK?
AnswerI seriously suggest checking the lower control arms AnswerTyre wear tends to affect this also, mine pulls left under decelration when the tyres are getting down. AnswerCheck right side lower control arm. If accelerate, pulls to right; if deccelerate (not breaking), pulls to left. Install new control arm ASAP! It is not a joke! Same for left side,but the pullings are reversed.You are SO CORRECT! The right lower control arm had a bad bushing in the rear. Thank you very much.
Be aware!! Replace both sides or you will be back to square one before you know it.. (From experience!)
Daewoo makes their own cars. It is an auto manufacturer in Korea that had been making cars for major companies for years, such as the 1994 Chevy Lamons. They decided to make cars under their own name. In 2000, while in bankruptcy, GM bought them. They a now a division of GM. They still produce Daewoo cars, but they are not sent to the USA.
it is produced in Ukraine (daewoo-zaz). Zaporijjya GM makes daewoo lanos
the camshafts are identical,take the bolt out of the camshaft sprocket and you will see how the camshaft pin is positioned, that is what makes a intake camshaft or a exhaust camshaft
The Daewoo Company Korea I believe
there the same engines as a kia
Your question makes no sense.
Usually when a car makes squealing sound after accelerating with the heater on, the serpentine belt is a little loose. It likely needs adjusting by a professional.
check and adjust belts
an accelerating charged particle or synchronized electric and magnetic fields
Daewoo makes their own cars. It is an auto manufacturer in Korea that had been making cars for major companies for years, such as the 1994 Chevy Lamons. They decided to make cars under their own name. In 2000, while in bankruptcy, GM bought them. They a now a division of GM. They still produce Daewoo cars, but they are not sent to the USA.
hi it sounds like your universail joints or tail shaft
Buick makes a clunking sound from trans area when accelerating.