Wiki User
β 16y ago17-22 Hg
Wiki User
β 16y agoedelbrock has a square flange gasket fo it
If it is a stock motor then yes it is. 600 CFM carburetor will be just fine on a stock engine.
The Edelbrock carbs work very well right out of the box, so if you have the correct intake manifold it should bolt right on with no problems. The Edelbrock website has all the info you need for tuning and connectivity.
I've had good luck with the Edelbrock 1406 right out of the box.
Hard to say, they have several intakes and carburetors for that application.
The edelbrock performer 350 crate engine has 310hp/375ft-lbs. So if you have the same cam, compression, etc., it should produce close to that.
Try 12 degrees initial and see if it pings. If not, try a little more.
The engine itself creates Vacuum once it is running.
In late 1987 chevy went to fuel injection on ALL there engines. From 1987 down will have a carburetor.
A small one with vacuum secondaries.
The vacuum lines on a 2000 Chevy Silverado run between the intake manifold and multiple valves across the top of the engine. The vacuum pressure is generated by the engine's compression.
on top of the engine, under the air cleaner