105 ft/lbs. There should be 10 bolts per head. You tighten them in a zig-zag pattern. Start with the center going from inside to outside. Next, tighten the bolts to the left of center, inside to outside. Then the ones to the right of center, inside to outside. Then to the left end, and lastly the right end. Good Luck The above answer is incorrect. The correct torque is 85 lb/ft. Look at the link below.
the correct torque for these bolts is as follows: 96lbs
You have to pull the stater and grind a space in the adaptor for a socket to clear to the torque convertor bolts.
torque for 2c engine cylinder head bolts
A C15 Caterpillar engine has dozens of torque specifications for many different engine bolts. The head bolts should be torqued at 350 pounds.
The head bolt torque for the Dodge 6 cylinder and V-8 engines is 50 ft. lbs. torque. If it is a diesel engine, the torque is 90.4 ft. lbs. Tighten the bolts by working from the center out, and alternating side to side. This prevents warping of the head.
Conrod bolts
How do I change the oil pan gasket on a 1999 Dodge Intrepid with 3.5 engine, what is the proper torque for the bolts.
45, 45, 65 ft lbs + 1/4 turn.
95 ft/lbs using engine oil to lube the bolts.95 ft/lbs using engine oil to lube the bolts.
Torque specs can be found in the Haynes Auto Manual.
The torque specs for a Cadillac depend on which engine it has. For most 425, 572, 368, and 500 engines, the torque for the head bolts is 115 ft. pounds. The torque for the cam bolts is 25 ft. pounds, and the torque for the valve covers is 10 ft. pounds.
215 in. lbs