answersLogoWhite

0


Best Answer

The plug gap is .60

User Avatar

Wiki User

βˆ™ 14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the spark plug gap for a 98 Chevy Malibu 2.4L?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the spark plug gap for a 95 Nissan 240sx with a 24L engine?

0.39-0.43 inches


Where is the oil drain plug located on a 1996 Pontiac grand am 24L?

On the oil pan.


How do you wire a starter on a 1999 Chevy cavalier 24L?

I'm assuming you mean "hotwire"? Don't try it. You will fry the computer.


Where are the spark plugs located on a 2004 Hyundai Sonata 24L 4 cylinder engine?

To locate and change the the (4) spark plugs on a 2004 Hyundai 2.4L 4 cylinder engine: Remove the (4) 12mm bolts from the decorative plasitc engine cover. Remove plastic cover from engine and place it off to the side out of your way. Standing in front of the car, the (4) spark plugs are located laterally (left to right) in the recessed area underneath where the plastic engine cover was removed. Note: This engine has (2) coils....They are located above spark plugs number (2) and (3) from left to right. Starting with the fist spark plug on the left: Remove the spark plug cable by pulling straight up on the insullated connector. Using a spark plug socket, remove the old spark plug and install a new one in it's place. To access the second spark plug from the left, remove the electrical connector and the spark plug cable wire from coil number (1) and then remove the (2) 12mm bolts that secure the coil to the engine. Spark plug number (2) is located directly under the coil. Lift the coil straight up removing the insulated connector from spark plug number (2). Using a spark plug socket, remove old spark and install a new one in it's place. Repeat same procedures for spark plugs number (3) and (4).


What could cause a '97 Stratus with a 24L to overheat then go dead and not crank again Engine is not seized Has spark No water in oil?

maybe some water stuck in the cylinders


Why 97 grand am starts then shuts down right after 24L replaced fuel filter pumps shooting gas and replaced tps?

Check plugs and plug wires---worked for mine.


How do you change the spark plugs on a 2001 Toyota tacoma with a 24L?

You need a six extension and a spark plug socket with a rubber stop inside. The spark plugs are located on top of the engine. They are about 4 inchs inside the head. Using the extenion put the socket with the rubber piece inside which will grip the plugs when they are unscrewed allowing you to remove the plugs. When installing use the same socket but press the plugs inside the socket so they are being gripped which will you to slowing lower them inside the head with the extension and get them started. I suggest you start them by hand.


Where is ICM located on 1995 Chevy Cavalier?

You didn't say which engine, but, The 24L DOHC engine is located in the top coil pack cover It is a rectangle shape plugin next to the fuel lines. On an 2.2L OHV engine follow the plug wires. It will be underneeth the coil pack. Either way the coil packs are sitting on top of the ICM....


What is the absolute value of l-24l plus l15l?

39


How would you fix 98 Plymouth voyager 24L that has codedianostic- misfire clyinder 1 van feels like it is struggling at time?

To fix a misfire in cylinder 1 of a Plymouth Voyager, start by checking the spark plugs, ignition coils, and fuel injectors for issues. It's also important to inspect the wiring and connections related to cylinder 1. Additionally, consider performing a compression test to ensure the engine's internal components are functioning properly.


What year is Johnson boat motor RDS-24L?

Johnson outboards, model RDS-24L, would be a 1962 year model, 40 hp. the boat motor is a 50 hp.


Why is my 1999 24L Old's Alero running rough after changing the plugs?

i think you disconnect one of the plug wires or you need to change one of them . It could be the oxygen sensor, valves, plug wires or a sticking fuel injector. You'll have to get a little more specific. If it ran well BEFORE changing the plugs and now it doesn't, perhaps 2 of the plug wires have been cross-connected.