0
What is the procedure for removing the a 5-speed manual transmission on a 1998 Dodge Ram 1500 4WD with a 5.2L engine?
To start, remove the drive shaft from the rear end.( there should be four bolts holding it on). Remove the shifter completely. Next, remove all of the bolts from the bell housing that fasten the tranny to the rear of the engine.(you will need to remove the starter and oil filter to complete this). Then, place a jackstand underneath the transmission and remove the crossmember with the transmission mount. In most cases, the collector pipe for the exhaust will need to be unbolted from the headers. Before removing the tranny, make sure all wires and clutch connections are removed. At this point, you should be able to drop your transmission. - good luck, and be prepared to spend a few hours doing this.
Add your answer:
Earn +20 pts
What is the gear ratio for a 2002 Toyota Tacoma with 2.7 engine and 5speed manual transmission?
3.91:1
What do you need to do to change a automatic galant to a 5speed?
To change an automatic galant to a 5-speed, you need a Computer for the Manual transmission of that year, and an engine.
How many kilometer per liter does 3Au engine consumes?
If 4speed transmission it consumes around 9 to 11km/L But if you're using 5speed transmission it consumes around 12 to 15km/
How is the transmission fluid on a 1994 Dodge Spirit 2.5 engine changed?
The fluid is drained by removing the transmission pan.
Is it possible to pull the engine from a 1995 Tercel without removing the transmission too?
I did it, just supported transmission and changed engine just like any other car.
Do you have to pull the engine out of a 98 Saturn sedan to replace the clutch?
To replace the clutch you must separate the engine and transmission. For a front wheel drive vehicle, separating the engine and transmission can only be accomplished by removing the engine.
Can you replace engine bearings without removing engine from car?
In some cars, you can get the rear bearing by dropping the transmission. For the rest, no.
How do you put a v8 in an astro van?
A V8 engine is put in a Chevy Astro van by removing the existing engine and removing all unused accessories. The engine can then be put into place, bolted to the transmission, and everything hooked up.
Where is the speed sensor in a 93 Honda delsol?
It is located on the top of the transmission, you can access it without removing the transmission as it is connected to the engine wiring harness.
How do I remove a dodge neon transmission?
The transmission on a Dodge Neon is removed by removing the axles, disconnecting the wiring harnesses, and unbolting it from the engine block. It can then be shifted away from the engine and lowered from the vehicle.
How do you remove 1998 blazer engine?
Begin by removing the engine wiring harnesses. Remove the motor mount retaining bolts. Disconnect the engine from the transmission. Lift the engine out.
How many quarts in the manual trans of 97 ford F150 with 4.2 engine?
The transmission is a mitsubishi M05D-R2 5speed transmission. The fluid capacity is 4 quarts of ATF, most guys with shifting trouble have seen shifting improvement switching to Mobil-1.
