0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is my speedometer acting up on my Monte Carlo?
The speedometer cable is likely bad
87 Monte Carlo ss hood release cable broken from release itself you need under the hood any ideas?
87 Monte Carloif 87 Monte Carlo has a cable type release clamp on a small pair of vice grips and pull hard.
Where is the odometer cable on a Monte Carlo?
connected to the back of the odometer and runs in to the transmission it pulls out
Where is the starter relay on a 2003 Chevrolet Monte Carlo?
Try on the top of the starter - follow the + battery cable
What does the shifter cable do?
The shifter cable connects the shifter to the transmission.
If you disconnect the battery cable on your 1972 Monte Carlo and it dies does that mean th alternator is bad?
Generally, yes.
How do you install a shifter cable on 1997 blazer?
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
How do you reset the check engine light in a 2003 Chevy Monte Carlo?
unhook a battery cable for about 3 minutes and re-hook.
How do you replace a broken shift cable?
Loosen the shifter cable not on each end of the shifter cable. The shifter cable will come off. Reverse the process to install the new shifter cable.
How to change speedometer cable on 1985 Monte Carlo?
Unhook it from the tranny and then the other end is up under the dash hooked to the speedometer, unhook it and take the cable out, just reverse the process for installation.
How do you replace the starter on a 1998 Monte Carlo z34?
Remove the positive cable from your 1998 Monte Carlo battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Can you use factory shifter cable with quicksilver shifter?
I tried it and it didn't work too well. I had three aftermarket transmission shifter brackets, and between them, I managed to get it to either shift from reverse to 2 low, or park to drive. The problem with the stock cable is that it is not adjustable for length. I am going to buy the B&M cable, which is adjustable. I already have the B&M shift lever.
