answersLogoWhite

0


Best Answer

NOTICE: The information contained on this site is presented for information only. OBD-Codes.com is not responsible for any actions you take on any vehicles. If you have any doubt as to repairs on your vehicle, please contact a qualified technician. Lack of HO2S-21 Switch, Sensor Indicates Lean A Heated Exhaust

Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time. You will likely not notice any drivability problems. A code P1151 may mean that one or more of the following has happened: * Short to VPWR in the harness or HO2S * Water in the harness connector * Open/shorted HO2S circuit * Corrosion or poor mating terminals and wiring * Damaged HO2S * Damaged PCM * Excessive fuel pressure

Leaking/contaminated fuel injectors

Leaking fuel pressure regulator

Low fuel pressure or running out of fuel

Vapor recovery system * Air leaks after the MAF * Vacuum Leaks * Improperly seated engine oil dipstick * Leaking gasket * Stuck EGR valve * Leaking diaphragm or EVR * Oil overfill * Cam Timing * Cylinder compression * Exhaust leaks before or near the HO2S(s) * See the above list of causes and go from there. Sources: MotorCraftService.com

User Avatar

Wiki User

βˆ™ 16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is P1151 code on ford e-250?
Write your answer...
Submit
Still have questions?
magnify glass
imp