answersLogoWhite

0


Best Answer

I really hate to be the one to tell you the bad news but it is possible that you have bent some valves. Take the spark plugs out of the missing cylinders and run a compression check on those two.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What else could be wrong if 2 cylinders are misfiring after getting water into the motor through the intake after the spark plugs and ignition coils have been replaced and it is still misfiring?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Must fuel injectors be replaced when a cylinder is misfiring even after a complete tuneup including spark plug wires has been performed?

Check the timing on your vehicle ,but there's more on why your getting a misfire


What is wrong with a 1998 ford escort sport if you are not getting no spark to the ignition coil or the plugs and have already replaced coil and checked wires?

CHECK THE IGNITION SWITCH,,, THEY HAVE A HABIT OF GOING BAD


Nissan D21 z24 Pickup It cranks won't start no spark getting plenty of fuel just replaced ignition module still won't start?

have you replaced and or tested both coils? are you getting no spark on the intake and the exaust sides?


Why won't my 1991 Mercury Capri won't fire replaced plugs and wires?

Assuming it is getting fuel and you have no spark, replace the ignition module.


How do you start a car that has been sitting for year you have replaced the battery?

I would definitely change the gas and probably the oil first. Check for spark and fuel getting to the cylinders.


Not getting electrical to ignition system of 1961 Ford Falcon?

I've replaced ignition switch, and starter solenoid, checked fuses, and battery, but I don't seem to be getting any electrical through to start the engine. I can jump everything and get the engine to turn over but not start.


Why would a 1988 Chevy Blazer S10 with a 43 engine 6 cylinder shake?

it might be a broken motor mount. there are two mounts located towards the bottom of the left and right side of the engine make sure you are getting spark to all cylinders. (check for Misfiring)


Jeep ignition 1990 Cherokee Pioneer when starts runs strong it takes from 1 crank to 100 times to start it it shuts off randomly I replaced ignition cylinder and ignition switch won't start why?

Check to see if you are getting spark (coil) and fuel


1989 Mazda will not start it is getting fuel and has a good spark from the coil to the distributor cap but has a week spark at the plugs Have replaced ignition coil distributor pickup coil plug wires?

try to get a new ignition rotor


Your 1998 gmc jimmy starts and then off acts like it is not getting enough fuel you have replaced fuel pump and filter what could be causing this?

You may have a faulty ignition switch. The ignition switch feeds the fuel pump.


The engine light on 2001 Grand Prix 3.8 liter is flshing When they did a scan it came up cylinder 1 was misfiring you replaced all plugs and wire but still getting same message What else could IT BE?

Coil, injector, internal engine....


What causes my Ford Mondeo engine still to run when ive switched off the ignition?

probably timing or valves. cylinders getting too hot which is igniting fuel that is left after it has been turned off