Try changing the fuel filter. I have a 1984 Mustang with 3.8L V6. On some older cars you tend to accumulate a lot of crud in bottom on fuel tank. And when you get to about 1/4 tank some of it comes up. I changed 2 filters in less than 6 weeks and have not had the problem again. Take a look at the motor mounts. I had a car that would stall when put in drive and while looking at it, when i shifted into gear the motor would tilt forward or back, some wires were being pinched off shorting out and causing the engine to stall when put into drive. If it shakes violently when it dies it is most likey your transmission. It happened to my Dodge.
If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"
Is your clutch bad or wearing out ?
what causes a boat motor 40 hp to stall when it is put in gear
Could be time for a tune up.
because you are engaging the clutch which cuts out the engine for a smooth gear change
check the idle speed with the car in gear, if it has a tac on the dash it should idle in gear at about 700 rpm if its too low the car will vibrate or stall.
Fuel injection or fuel contaminated?
I just put a new battery and alternator in my car, but when i put it in gear or start slowing down to stop..the car die out. Also the brake light is continely on.
car starts but when i put it in gear it stop
The engine has problems; when the engine is put into gear it becomes loaded but does not have the power to support the load at idle. Have it scanned for possible faults/codes, run diagnostic on the engine, and/or tuning it up may help.
Put your hazards on then restate the car and be off.
The clutch is master and or slave cylinder are bad