0
Add your answer:
Earn +20 pts
Where are the blower resisters on a 1998 Ford Ranger pick up locateed?
The blower resistor assembly is located on the heater case to the right of the blower motor. The blower motor is located under the hood on the passenger side firewall.
Where is the blower motor resistor for 1998 Ford Ranger?
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
Which was the maximum speed of pick-up dodge 200 motor perkins diesel 6cyl 73HP 1973?
The maximum speed of pick-up dodge 200 motor perkins diesel 6cyl 73HP 1973 is 180km/hr.
2000 Chevy pick up fan only blows on a high speed?
You have a bad blower motor resister.........
How do you test blower motor resistor on a 1994 Toyota pick-up?
Remove and test with an ohmmeter Explain how to test with an ohmmeter?
Where is the blower motor located on a 1996 Chevrolet S 10 Pick up?
Under the hood, on the passenger side of firewall, far corner.
Where is the blower motor on a 2001 Chevy S 10 pick up?
Under the hood, on the passenger side firewall, close to the passenger fender.
What fuse controls the heater on 94 dodge Dakota?
when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover. # when you pick up the fuse cover under the motor there should be a diagram on the inside of the cover.
Where is the blower resistor located on a 2001 Ford Ranger Pickup?
The blower resistor assembly is located on the heater case to the right of the bloser motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
Where is the heater blower resistor on 1994 dodge Dakota pick up?
It is under the hood, far passenger side of firewall. It is near the top, just above the wiring harness.
How do you replace a blower fan motor on a 1978 Ford pick up truck with factory air?
You have to pull the black box off of the firewall the you can get to the bolts from behind the dash
How do you change blower motor 1991 Toyota pick up?
it is located under the glove box under the air duct unplug the wire remove the three screws pull out motor and install new one reverse sequence
