Are you looking for the specs. or more. Let me know on my board I will try to help.
Factory stock ignition timing for the Corvette 327 ci 350 HP is 4 degrees BTDC.
There were a few different 327's offered that year, but, if you go 4 degrees advanced, or BTDC, it will run fine.
its a 1967 engine most likely from a chevelle with 275 HP
First of all the 1995 Z28 had a 350 (LT1) not a 327(the 327 stamp on your engine block has nothing to do with the size). The specs for the '95 Z28 350 are: 275hp and 325 lb-ft
The degree timing for a 327 cubic inch engine for a Chevrolet Corvette with is 4 degrees before top dead center. This engine is rated at 300 horsepower.
non existent.327 is a Chevrolet engineBut in a 1967 327 on a Chevrolet the Point gap is 19 thousands. Dwell angle is 28 to 32. Idle 700 RPM's
327/275 and 300hp, 8 degrees btdc.
its next to the thermostat housing
It is on the left / drivers side bottom rear corner of the engine.
The 1963 Corvette has a top speed of 229 miles per hour. This model car has a 360-hp fuel-injected 327 V engine.
50 lb/ft lubricated with oil. Check out the link I posted.