Is this security light the type with the built-in motion sensor?
If so, these also have a built-in photo-eye so that it does not come on during the day. The photo-eye can go bad where the symptom is "on all the time" Also some of the motion sensors have a chip inside that "locks on" if you flip the wall switch on and off three times quickly. Once "locked-on" I think you have to turn the wall switch off for at least 1 minute to reset.
when i got into the car to start it it wouldn't even try nothing it had power to everything else and a new battery it just flashed security what can i do to disarm the security system
There could be many reasons why a security light is staying on. There may be an animal that is in front of the light moving all the time such as a cat or even raccoon. The light may also be defective.
Most light bulbs waste energy as heat. Even LEDs. Large light bulbs require more power.
The security module has gotten confused. To correct, disconnect the the hot lead of the battery for about 3 minutes and then reconnect it. This resets the module and the light should not be on until the remote security lock button is pressed.
you may have a loose wire to starter
The 2001 Chevy Blazer does have an ignition security system that is controlled by the computer in the vehicle. The light might come on because of an error that is coming up in the computer due to a key problem or an ignition problem. This is a common issue with the 2000 and 2001 Blazer.
No.
In nearly everything that we do we are the cause of global warming such as driving a car, turning on a light, or even the smoke from factories.
GFCI outlets have internal circuitry that can power the indicator light even when there is no power flowing to the outlet itself. This function allows you to easily identify if the outlet has tripped or if there is a fault in the circuit.
They cannot.
If you haven't even moved the car yet and the light came on, check the brake fluid level. If it is low it will trip that light to come on. Time to have the brakes inspected.
its hard to answer the question of how electricity makes a computer work but how it stores data is easy it writes it to a magnetic disk in the form of ones and zeros its like turning a light on(1) or off(0) hope this helps you out