0
Add your answer:
Earn +20 pts
What is the ratio for 2000 s type jaguar 4.0 rear differential?
4.2 auto ratio = 2.87For auto gearbox RatioEngine 3.0/4.0/2.5 3.31Engine 2.7 3.07Engine 4.2 2.872.7d manual gearbox 2.69
How do you re install the rear view mirror on a 2000 Grand Prix with auto dimming There is a metal clamp that you can not figure out how to put back on?
Get some rear view mirror adhesive from an auto parts store.
How do you replace a 2000 Ford Mustang rear windshield?
By calling a company that installs auto glass. Not a DIY job.
Where is the air compressor for the auto level system in a 2000 Pontiac Montana?
Left rear quarter near the axle.
Is the rear axle ratio the same between auto trans and man trans on a 1994 GEO tracker?
No, it is 4.62 for the automatic and 5.12 for the manual. this is due to the difference in the transmission's gear ratio. If you were to put a 5.12 rear with an automatic you would lose 10 MPH off your speed.
Where is auto choke on a 86 comaro?
If 2.8 (6 cylinder) fuel injected -- no choke If carb. should be a round black cap that has spring inside (on passenger side of carb.)
Is the diff ratio the same on a standard and auto Chevy silvarado?
Probley not a stright stick trans. is geared different then a automatic. But the rear end gear ratio. could very well be the same. Not sure I understand your question.
What size rear shoe brakes do you need for a 2000 Mercury Cougar V6 25L?
Call your local Auto Part store.
Where can you find rear spoiler for ford Windstar 2000?
ebay.. Craigslist Auto salvage / junk yard Various on-line sources of new & used auto parts - try searching on "Windstar spoiler"
What size brake pads go on rear of 2000 Jeep Cherokee?
Exactly what they will sell you at any auto parts store. They will know the correct size.
Stock gears for a 2000 Chevy S-10?
on my 2000 s10 ls v6 with an auto i have a 3:42 rear end on a 4 cyl version its a 4:10 i dont know about the extreme versions but i know some had a zexel torsion limited slip rear end
Why auto transformer is lighter than conventional type?
because the copper is saved in the auto transformer that is the ratio of weights of copper in auto transformer to normal transformer is (1-(1/a)) where a is transformer ratio
