Good luck. The plastic surround on the speaker can be popped off, exposing the mounting screws of the speaker. However, unless you park your Intrigue in a garage constantly, the plastic has likely become brittle, and the surround will likely crack or one of the tabs will break off. An alternative may be to remove the whole door panel, but similar problems with brittleness and cracking. could possibly use a butter knife to find tabs and gently push down to pop them out to get to speaker screws
6x9
remove the speaker covers from fear deck. remove the four screws that hold the speakers in the rear deck. four screws hold each speaker in place. unplug the wires from the connecters. if aftermarket speakers cut after plug and splice new speaker wires into existing factory wires. reverse the procedure to install new speakers.
on the bottom of door panel there are two Philip head screws remove them first then use a butter knife and carefully slide along the edges of speaker panel when you come to a tab push down gently continue until all tabs out and carefully pull up and out there might be insulation attached to panel separate the two and speaker will be exposed. on speaker there four .25 inch screws.
The speaker greets the raven with curiosity and intrigue, as they are intrigued by the mysterious visitor standing at their chamber door.
carefully remove the speaker cover from the rear deck. then the speakers are exposed, remove yhe four screws that hold the speaker mounted, then unplug the wire clip and remove old speaker. then cut off plug, strip wire casing exposing bare wire. twist exposed wires from existing wire and the new speaker wire tape them up real good make sure no wire is exposed. plug the female ends on new speakers place speaker in back deck replace the four screwsand place cover back on and do the same thing to opposite side.
Remove the door trim panelRemove the speaker mounting screwsPull out the speaker,disconnect the electrical connector from the speaker and remove the speakerInstallation is reverse of removal
Removing in-ceiling speakers must take into account the type of ceiling in which they are installed. Typically the panel that the speaker is set in can be lowered and the speaker can be lifted out for removal.
driver's side, under the dash. If you remove the left speaker cover and speaker, you should be able to see it and have access to the removal screws
The front speakers are a 5 1/4" inch component speaker located in the door. The back speaker is a 6"x9" located in the rear deck.
Only if your amplifier is capable of driving a 4 ohm speaker. Some have a switch on the back to select 4 or 8ohm speakers. Details should either be printed some where on the back of the amp or the instruction manual
the factory radio is bad on the inside or speaker ohm load is different are your speakers aftermarket?
Remove the instrument panel pad. Remove the speaker attaching screws. Remove the speaker and disconnect the electrical connector. Installation is the reverse of removal.