Yes the timing chain position marks for engine 4.0 ford explorer eddie bauer
The marks are on the bottom pulley , you may need to get a white marker to hi light it , so it will be easier to see with a light .
need to see the marks for it
need cylinder order for 351 wins
Timing is computer controlled.
if you look behind the water pump straight down u can see the timing marks.
you may have to get underneath the car to be able to use the timing light
the marks are very vague and hard to see, the timing is a little more complicated than some this size. Its supposed to be 10 degrees out and the cam has an awkward hole that has to be straight up. the other timing marks on the intermittent and the crank should be facing each other, still the marks are hard to see on them so be careful and good luck. If you add chalk to where the timing marks are on the crankshaft with chalk and wipe the excess off, this will make the timing marks easier to see. The marks are recessed in the crank and the chalk will fill them up. Hope this helps you!
they are under the timing hole cover in the top of the transmission. it is a large(27mm) Allen plastic nut remove it to see the timing marks
if you mean the ingintion timing marks, they are on the crankshaft pully. Use a rag and some cleaner to see them clearly.
see 200 kia sportage timing , i also have diagrams .
Go to a scooter store or go online, they sell cdi units that have a potentiometer that will allow you to adjust the timing, just need a timing light and remove the left engine plastics to see the timing marks