on a 2005 Honda Accord where is the low pressure AC switch
Low on freon, faulty pressure switch, faulty clutch. Jumper the low pressure switch with a paperclip (can running, AC on), if the clutch cycles, it's either low on freon, or the low pressure switch is bad.
It don't have a low pressure valve. the high pressuer sensor is in the high pressure line next to the raditor. It don't have a low pressure valve. the high pressuer sensor is in the high pressure line next to the raditor.
The 1994 Pontiac Trans Am air conditioning low pressure switch is on top of the air conditioner compressor. The low pressure switch will be labeled as the low pressure port.
Of which low pressure switch are you speaking? Engine oil pressure switch? If you're checking that, remove the oil pressure sending unit and temporarily put in an oil pressure gauge. If you're checking the AC low pressure switch, pull the switch from the AC low pressure line, Jumper the switch socket and see if the AC compressor comes on. If it does, you either have low refrigerant pressure or a bad switch. If you KNOW the pressure is up and everything else works, you have a bad switch.
No, the low pressure port and the low pressure switch are not the same thing. The low pressure port is used for connecting a gauge to measure refrigerant pressure in the system, while the low pressure switch is a component that monitors the pressure level and can shut off the compressor to prevent damage.
The 1997 Pontiac Sunfire air conditioning low pressure switch can be found on the top of the air conditioning compressor. The low pressure switch will be labeled as the low pressure port.
Look on top of the drier probably at the passenger side firewall
The 1997 Toyota Avalon air conditioning low pressure switch can be found on the top of the air conditioning compressor. The low pressure switch will be labeled as the low pressure port.
The low pressure switch is mounted near the ac compressor. It is a two wire switch mounted in the low side line.
This vehicle does not have a low pressure switch. It has a pressure transducer instead. The pressure transducer is located on the refrigerant line next to the alternator pulley.
A pressure switch a valve that shuts off the unit when the pressure is to low or to high