0
your selection sensor is bad or the sensor hasn't figured out you are in 2wd.
try driving in reverse for a good couple hundred feet, then pull forward, sometimes this will help the sensor realize what position the transfercase is in.
the sensor is on the top front of the transfercase
Add your answer:
Earn +20 pts
2001 part time light won't turn off?
2002 jeep liberty part time light wont turn off
Jeep liberty Part time light stays on why?
There is a malfunction in the circuit that runs the light. Could be with the switch on the transfer case, in the wiring, or in the cluster.
2003 Jeep liberty check engine light on?
dears time to time i have check engine comes jeep cherokke 2004- 6c .pls i want your helape.
How fast can you drive 2003 Jeep Liberty in part time 4WD?
recommended maximum speed is about 55mph
A warning light has appeared on your 2004 Jeep Liberty it says Part Time in yellow what does it mean?
Either yo have shifted into four wheel drive, or there is a malfunction in the four wheel drive system.
What does part time mean on my 2004 jeep liberty?
That is 4 wheel drive. You are allowed to drive in that range on slippery surfaces.
What causes the part time 4wd light to remain lit in 2wd and turn off in 4 wd when a 2003 Jeep Liberty Sport is not stuck in 4wd?
AnswerI have the same issue with my '03 Jeep Liberty Renegade. I let a mechanic look at it... it seems there's some sort of sensor to be replaced. Expensive! I'm not mechanically inclined and will not be able to install this myself. It must be a "Jeep" thing : )
2006 jeep liberty 3.7 part time 4x4 will not go out Any idea where this sensor is located?
top front of transfer case
What does part time and full time light mean in my jeep liberty?
Part time is the type of four wheel drive where the front and rear axles are directly locked together in the transfer case. It is meant to be used "part of the time". such as on ice or mud. Full time has a gear set in the transfer case that allows the front and rear to turn at different speeds. It can be used "full time" or all the time.
How do you change a shift console bulb on a 2002 Jeep Liberty?
Begin by removing the 2002 Jeep Liberty shift console retaining bolts. Lift the shift console up and the light bulb will be visible. Take hold of the light bulb, push in and turn at the same time to remove it. Reverse the process to install your new shift console light bulb.
Who made a 2000 Jeep?
Jeep is part of Chrysler, which was part of Diamler Chrysler at that time.Jeep is part of Chrysler, which was part of Diamler Chrysler at that time.
How much time to replace a motor in 2004 Jeep Liberty?
For my Liberty it took about 3 hours (with all equipment).
