answersLogoWhite

0


Best Answer

No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is an ECM and ignition switch the same part difference on a jeep wrangler 1990 2.5?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Instructions on how to remove ignition switch on a 1990 Lexus LS400?

Remove the retaining ring from the top of your 1990 Lexus ignition switch. The ignition switch will slide out. Remove the wiring harness.


Replace ignitio switch in a 1990 Pontiac Bonneville?

Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


How do you remove the ignition switch on a 1990 Chevy half ton pickup?

how do you remove the ignition switch on a 1990 chevy half ton pick-up?


Where is the ignition switch on a 1990 bronco xlt located?

The ignition lock is where you put the key. The ignition switch is located on the top of the steering column directly above the brake pedal.


Where is the ignition switch located on a 1990 Cadillac DeVille?

On the steering column????


How do you change the ignition switch on a 1990 Cadillac DeVille?

Take it to a shop


Where is the 1990 wrangler inertia switch?

It doesn't have one, the fuel system is relay controlled by a computer.


Why does your key not turn in your ignition in your 1990 dodge ram van?

Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA


How do you change an ignition switch on a 1990 Cadallic?

you have to go under the dash and take out the steering column. and the ignition switch should have a wire going down to the bottom of the column coming from the ignition lock.


What can be the problem with your 1990 Jeep Wrangler if your headlights go out?

If your high beams still work it is the dimmer switch.


How do you drill out the ignition switch on 1990 lincolon town car?

i need help son started drilling out ignition switch cause he lost his keys how do you do it ? 1990 lincolon town car helpjust keeep on drilliln till it pops


Can the ignition switch in a 1990 Chevy pick up cause the transmission to not shift?

NO, there is no coalition between the ignition switch and the transmission. The ignition switch does 2 things. Turns on power to the electrical system for the engine and supplies power to the starter during start-up.