If the speakers are in the door panel then you must remove the door panel to install new speakers. You can only bypass removing the door panel if the speakers are located elsewhere.
Remove the door panel. Towards the front of the door there are two screws holding the mirror on. Inside the door are two connectors that connect the mirror wires to the door. I have a 98 and if it is the same process that's all you need to do.
How do you remove and install front door panel 1985 Nissan Sunny
taking off the door panel of the aurora is easy remove two phillip head screws from the bottom of the panel and the one under the cover near the arm rest and gently lift the panel up ande out until the door panel is free
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
Remove inner door panel for access
Take the door panel off, remove the old reg. Install the new one... If you don't know how to take the door panel off, best to stop there
There are 3 screw at the bottom of the panel then you can use a door panel remover which the local auto stores sell them to change the handle you will have to gut the door to locate the handle.
The door push-pins are suppost to be on the door panel. When ready to install those push-pins are inserted inside the door holes. Push them in until you hear a click. After that reinstall the door handle and srews. exc.
The door panels are held in place by clips--you will probably have to buy them seperately from your panel. If you get a panel, it will most likely come with instructions.
remove door panel, install new window
Start by disconnecting the negative battery cable, battery is under the rear seat. then remove all fasteners to the door panel,the panel slides up. Remove the plastic protector and remove the bolts that hold the regulator/motor then replace and reverse the order to install.