If by "still fire" you mean if it will start, it depends on how far off the timing is. If it is not too far off, the engine will start but miss badly and the timing will have to be re-set. Otherwise, the engine will just crank but not start. You can check the timing by finding Top Dead Center on the #1 spark plug and remove the distributer cap to see if the rotor is pointung to the #1 spark plug wire tower. If it is not pointing correcly, you can loosen the hold-down bolt on the distributer and manually rotate it. Once the engine starts and warms up, you can then slowly rotate the distributer clockwise and counter-clockwise until you get the best "purr" of the engine. For a more precise setting, use a timing gun to set the timing. If by "still fire" you mean the spark plugs stilll fire, yes they will if there is nothing wrong with the firing system. If you do not get a spark or get a weak spark, you will have to check the plug wires and all components, including the coil.
timing that jumps, usauly is motor turns over but does not fire. Or motor back fires, either out of carberator or muffler/tail pipe. you can also get a timing light, and point it at the timing metal indercator, just above the the pulley on your engine.
In the 1977 Ford TRUCKS it's ( .044 inch )
My 98 ford Taurus jumps while idlingidling
it's a 1977 ford ltd
Remove the glove box and you'll have access to the heater core, still not easy.
Sometimes if the timing belt jumps a cog or two at idle the engine will still be OK even on an "interference motor". If, however the belt snaps at highway speeds, it can bend the valves.I hope this helps you. Mark
If it is an automatic than it is probably the torque converter
Hod Ford died on 1977-01-29.
Kate Ford was born on 1977-06-15.
Adrian Ford died on 1977-07-07.
have a miss fire on a3.0 1998 ford what are possible causes
i have a ford focus 1.8 petrol S reg. When i put it into reverse gear it jumps out what is the problem please ?