0
Remove the cover from the strg column by removing the 7/32 screws from underneath. Pry off the ign cylinder cover...it just clips on. Put the key in acc position. On the top of the cylinder housing there is a button Depress the button and pull out the cylinder. Or there may be a small hole on top of the cylinder in which you need to put a small pick into to release the cylinder. For this type yoy must unplug the ignition switch and turn the key to crank and hold it there while you pu sh in the pick to release the cylinder. Then back to ACC while pullinjg out to get the cylinder out You now have access to the tumblers but you have to disassemble the cylinder by removing the gold coloured retainer
Add your answer:
Earn +20 pts
How do you remove the headlight to replace the bulbs on a 2000 Saturn sl1?
How can I replace the headlamp on a 2000 Saturn SL1
How do you replace the ignition switch on a 2000 Ford Expedition?
How do you replace the ignition switch on a 2000 ford expedition?
How do you replace distributor on 2000 Saturn?
The 2000 Saturn does not have a distributor. Instead it uses a "coil pack" system.
How do you replace the tumbler on a 2000 Toyota Camry?
Hello, if the tumbler has bent or broke, unless you know alot about locks and have a rekeying kit, your best bet is to take it to a locksmith.
How do you replace fuel sensor on 2000 Saturn?
Sending unit integrated into pump, have to replace whole thing
How do you remove and replace a power steering pump on a 2000 Saturn sl1?
lease gas cap on 2000 sl1
Is there an ignition module on a 2000 Saturn sl2?
Yes, its inside the coil interface (the thing that the two coils are sitting on)
How do you replace the steering column in a 2000 ford focus?
Program a new key and ignition to a 2000 ford focus
How do you replace the thermostat on a 2000 Saturn sl2?
http://youtube.com/watch?v=DrCSJpbDCiI
Cost to replace motor mount 2000 Saturn SL2?
The cost to replace the motor mounts on a 2000 Saturn SL2 ranges from $500 to $1,000. The high costs are due to the labor intensive process of disconnecting and raising the engine assembly.
How do you replace an ignition switch in a 99 suburban?
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
How do you replace ignition switch on a 2000 silverado?
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
