1. Remove the center "bezel" by removing two screws on the bottom. The bezel will now snap out when pulled out.
2. Remove the radio. The radio is held in by 8 screws. Disconnect from antenna and wiring harness.
3. The climate control unit is now exposed. Remove the four screws holding it in the bracket.
4. Remove the air control door cables (two of them). Depress the clips while pushing the eye hole up. This is very tricky and tale patience.
5. Disconnect the wire connectors.
6. The units should now be ready to remove.
7. Installation is much simpler. Reverse steps 6 to 1.
A 2001 Chrysler Sebring does not have a cabin filter.
Chrysler sebring ignition damage by thief key doesn't work how do you replace?"
No, the 3.2L will not fit a Sebring.
The Chrysler Sebring cruise control switch is located beneath the dashboard, on the drivers side. The cruise control switch should be labeled as such.
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
60.00 $
It will cost between $300.00 to $500.00 to replace the rack and pinion on a 1996 Chrysler Sebring. This cost includes labor and parts.
It would be very expensive considering that car doesn't have a carburetor.
The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.
Drop the fuel tank
It doesn't have one.
Pull out old, insert new.