answersLogoWhite

0


Best Answer

First step is to get inside the door - See "Related Questions" below for details on removing the door panel.

A couple of nuts to release the exterior handle, a linkage connection, and swap over the key cylinder.

Piece of cake and you'll be done in only 7 or 8 hours... Oh wait, not quite that long - hour or so. ;)

NOTE: Please consider coming back and adding your experience to this question - any tricks or traps that will make it easier for the next person.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to replace a broken door handle on a Ford Windstar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why will door not open with inside handle on 1996 Ford F150?

Broken door handle. replace it.


Replace freeze plug on a 1998 ford Windstar?

Replace freeze plug in a 1998 ford windstar ?


Replace rear side window 99 ford windstar?

where can i buy a side window for my 99 ford windstar lx


How do you replace the evaporator in a 99 Ford Windstar 3.8L?

I don't know how to do it, but the dealer is charging me $2075.00 to replace it on my 2000 Windstar!


How do you find and replace an actuator for a 1999-2003 ford windstar lx climate control switch?

electric window binds on 2003 ford windstar


How much does it cost it replace the transmission on a 2002 ford windstar?

About $2500.00


How much does it cost to replace a Ford Windstar transmission?

transmission bands


How do you replace the right sided vent blower ford windstar?

It sounds like the problem is a broken blend door. Before replacing the thermostat or any other component of the Windstar's HVAC system, be sure to check your blend door for functionality FIRST. The most common issue with heat or A/C in the late model Ford windstar is a broken blend door. A broken blend door actuator is almost as common as a broken blend door itself. Typically, the fix requires disassembling the entire dash and replacing the whole plenum box, which can be a costly repair.


How do you fix a broken hood release on a Ford Windstar?

AnswerIf it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable. AnswerI assume the handle broke off in the car. You will have to by a new cable/handle assembly ($30.00) so I would: Cut the remaining handle and end off the cable housing so you can get at the inner cable core. Then take a vise grip and pull on the inner core to release hood latch. New housing/cable assemblies are available at your Ford dealer.


How do you replace a voltage regulator for a Ford Windstar?

The voltage regulator is built into the side of the alternator.


How much does it cost to replace plentum gasket on ford windstar 2002?

Which plenum-intake or. . . .


How much should it cost to replace the water pump on a '95 Ford Windstar 3.8 V6?

I just had my water pump replaced on my '96 Windstar at a Ford dealer and it cost me $575.