There is a special Ford tool you can get at most automotive stores. It is two sort of "U" shaped pieces of thin metal that you push into the four holes (Two on each side) of the radio. You should feel, or even hear a click type noise when the tool disengages from the locks holding it in. After that you will have to wiggle and gently pull the radio out. Sometimes they are really tight. Be careful not to damage the trim around the radio, its just cheap plastic.
DH
specs on how to replace a heatercore on a 1993 ford explorer
How to remove fan clutch on 2003 ford explorer
remove the screws from the swivel bracket that is attached to the roof to replace reverse the process
To replace the radio on a Ford E350, first remove the bezel from around the existing radio. Then, release the clips on either side of the radio and remove it from the dashboard. Then, release the wiring. Place the new wiring on the replacement radio and insert it into the dashboard. Lock the clips in place and replace the bezel.
How do you replace evaporator on a 1992 ford explorer?"
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
pop the trim off around radio(the bezel where you have the 4x4 buttons )and you will see screws holding it in should be 7mm some fords used 8mm if the radio was a model with holes 2 on left and 2 on right you can go to autozone and buy the ford radio keys for around $5
I AM TRYING TO REPLACE A RACK AND PINION IN A 1997 FORD EXPLORER COULD YOU TELL ME OR GIVE ME A PICTURE ON HOW THE OLD ONE COMES OUT>
how do you replace the overdrive sensor on a 94 ford explorer
The spark plugs on a Ford Explorer are replaced by first disconnecting the battery. Remove the spark plug using a spark plug socket. Replace with the factory recommended spark plug.
You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.
how do you remove a fan blade from a 1998 ford explorer