0
The grove on the front of the pulley requires a sleeve in a u shape that slides over the pulley grove and a fine threaded bolt is part of the the sleeve assembly than you tighten the bolt which in turn pushes on the pump shaft removing the pulley. They are avaible at NAPA Stores
Add your answer:
Earn +20 pts
How do you remove power steering pump pulley on 1999 lesabre?
Pulley is pressed onto pump, you need a puller to remove.
How do you change your power steering pump on a 1999 mazda b2500?
You need a special tool, pulley puller and installer to remove the pulley first then you remove both hose and bolts to remove the pump, then install new pump and hoses, bolts and finally install the pulley with the special tool, never try to hammer in the pulley, if you do new pump will brake
How do you change 98 a4 diesel pump?
Remove the belt from your diesel pump. Remove the diesel pump fuel lines. Remove the diesel pump retaining bolts. Reverse the process to install your new diesel pump.
How do you remove the steering pump pulley on a Nissan 200sx?
Take off the sockets and remove the pump pulley.
97 Ford F-350 diesel with a 7.3 power stroke how do you remove the power steering pump pulley?
n way around it you have to pull the radiator to get the puller on the pulley
How do you remove Allen screw from power steering pulley?
That is not a Allen screw in there. That is part of the pump shaft. If you are looking to remove the pump pulley you will need a power steering pulley puller. This tool will help you remove it and replace it, without the puller you will damage the pulley or the pump or both.
How do you remove fan from water pump on 96 dodge 3500 1 ton?
36mm wrench and a holder for the pulley. The fan is reverse threaded on a diesel.
How do you take the power steering pump off a 1999 Pontiac grand am?
First remove the serp belt, then you will have to remove the pulley from the pump, if the pulley has no holes, other wise use a 13m socket with a 3in extension, & remove the 3 retaining bolts & loosen the lines & remove. . Pretty easy. . good luck. .
Where is oil pump on 7.3 ford diesel?
Simple enough. pull the harmonice balancer, aka the crank pulley. remove the crank seal and there is the low pressure motor oil pump for the 7.3
How do you remove power steering pump in 1995 Toyota 4runner?
To remove the power steering pump, you will have to disconnect the air control valve hoses( two of them buttom of pump) then the retun hose. then the high presure hose. the pulley well have to be removed before you can remove the pump. the way to remove the pulley is by removing a nut that holds the pulley in place. then to frace the pulley off the pump use a ball joint separater tool between the pump and the pulley and hammer it until the pulley slides off. then unblot it form the bracket.
How do you remove and replace a water pump on a 1999 ford contour?
Drain antifreeze. Jack Passenger side of car up. remove wheel well skirt. loosen pulley bolts on water pump before removing serpentine belt. loosen a/c compressor and slide forward about an inch. remove pulley from water pump. remove 4 bolts holding water pump in. remove water pump. reverse sequence to put new in.
Hw do you remove power sterring pump pulley on a 91 Cadillac Seville?
Begin by removing the power steering pump belt from your 1991 Cadillac power steering pump pulley. Remove the power steering pump pulley retaining bolt. The retaining bolt will be in the center of the pulley.
