0
1 Remove the plug on the oil pan with a wrench and drain the oil into a drain pan. Disconnect the negative battery cable. Place a support jack under the crankshaft pulley.
2 Remove the support bolts on the front and rear engine mounts, along with the hold-down brackets on the two rear refrigerant/heater pipes.
3 Disconnect the front and rear transaxle bolts and the brace holding the transaxle to the engine. Unhook the connector on the oil level sensor.
4 Loosen the bolts on the oil pan, working from the outside towards the center. Remove the pan and scrape away the old seal with a paint scraper. Make sure that all the parts are clean, and that the old gasket seal has been completely removed.
5 Put a new gasket in place and seal it with silicone sealer. Replace the oil pan and tighten the bolts in sequence, starting with the inner bolts and working out.
6 Replace the connector on the oil level sensor, the front and rear transaxle braces, the exhaust inlet pipe, the crossmember bolts and crossmember, and the front and rear engine support through-bolts.
7 Slide out the support jack and lower the vehicle. Fill the engine with clean oil. Mercury recommends that the optimum oil for the Villager is SAE 5W-30.
Add your answer:
Earn +20 pts
What is the oil capacity with a filter change for a 2000 Mercury Villager?
According to the 2000 Mercury Villager Owner Guide : With engine oil filter change the 3.3 litre V6 engine takes : ( 4.0 litres / 4.2 US. quarts of 5W-30 engine oil )
Where is located the drain of a mercury villager 2000?
You mean the oil drain? In the oil pan.
How much oil for a 2000 mercury villager?
4.2 U.S. quarts ( 4.0 liters ) with engine oil filter change , according to the Owner Guide
How many quarts of oil does a 1995 mercury villager need during an oil change?
I assume it is the same as the ( 1996 ) Mercury Villager : With engine oil filter change : ( 4.2 US. quarts of 5W-30 engine oil )
What does Pennzoil PZ-109 oil filter fit?
2000 mercury villager
How much oil do you put in a 2000 mercury villiger?
According to the 2000 Mercury Villager Owner Guide : For the 3.3 litre V6 engine : With engine oil filter change : ( 4.0 litres / 4.2 US. quarts of 5W-30 engine oil )
How many quarts of oil in a 2001 Mercury Villager?
According to the 2001 Mercury Villager Owner Guide : For the 3.3 liter V6 engine : With engine oil filter change : ( 4.2 US. quarts of 5W-30 engine oil )
What oil was 1996 Mercury Villager use?
5W-30 is the preferred oil ( according to the 1996 Mercury Villager Owner Guide )
How much oil does 95 mercury villager take?
According to the ( 1996 ) Mercury Villager Owner Guide : With engine oil filter change : The 3.0L V6 engine takes ( 4.2 U.S. quarts / 5W-30 PREFERRED )
How do you do oil change on Mercury Villager?
The same way you do on any other vehicle. Drain the oil, remove the filter, replace, refill.
What is the oil capacity with and without oil filter change for 1995 Mercury Villager?
without oil filter 3.7 quarts with oil filter 4.2 quarts
How many quarts does a mercury villager need with a new filter change?
I looked at the Mercury Villager Owner Guides from ( 1996 , 1999 , and 2002 ) With engine oil filter change : Each Owner Guide shows ( 4.2 U.S. quarts )
