0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
1988 jeep wrangler runs while cranking quits when you let off?
you have an open circut in your ignition switch change your ignition switch.
How do you change ignition switch without key 96 jeep Cherokee was stolen and recovered?
Locksmith?
How do you reset the oil change indicator in a 2007 Jeep Wrangler x?
Switch the ignition ON - then pres the fuel pedal three times - then switch the ignition off .Thats all - miracle is done.
How do you change ignition switch on 1981 jeep wagoneer?
you must remove the steering wheel and turn signal from column. then you can acces the screw to remove the switch.
What does an ignition switch do for a 1997 jeep?
It engages and disengages the lock that starts the vehicle. There are 2 parts to the switch. The ignition switch and the lock assembly.
99 Jeep Cherokee Laredo stay running after turn off the ignition switch?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
What could be wrong if your ignition on 1989 Jeep Cherokee wont turn completely?
either the ignition switch or the lock cylinder itself is bad. I would change both and check the rod that goes into the switch to make sure it is not binding up
How do you change ignition lock on 1974 jeep cj5?
The dash mounted ignition switch is spring loaded. The face is held on by two hooks and stubs.. It is removed by reaching up behind the dash and pressing the back of the switch towards the dash, then turn the face of the switch counter clockwise to release..
Why does my jeep run when you hold the key on but stalls when you let go?
You have a bad ignition switch
Can you reset the oil light in a Jeep Liberty?
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
How do you change ignition switch on Jeep Comanche?
Do you mean the ignition key or the ignition switch? The ignition switch is located on the top of the steering column above the brake pedal. It's held on by 2 bolts. It's a lot easier to work on with the column removed. If you mean the ignition key. You need to remove the steering wheel, lock plate and turn signal switch. The key tumbler will either be held in by a screw or a tab on the tumbler. There are several sources on the Internet with detailed procedures.
Your 1996 jeep 4 liter will only run if ignition key is kept in the start position?
Probably a bad ignition switch.
