No, the brake lines on a 1997 Wrangler are typically not metric. They are usually measured in inches.
You remove the wheels to replace brake lines.
You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied
How do i replace brake lines on a 2000 grand am
The hose goes from the diff to the frame, remove the two brake lines from the block on the diff, remove the mounting bolt, then disconnect the hose from the brake line at the frame. Install then bleed the brakes.
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
Don't drive it until you correct the problem.
replace the line and fill and bleed breaks.
Check
how to change brake lines on a 1996 ford econoline e-150
If you are talking about the steel brake lines, most likely the rear lines, then replace both from front to back.