answersLogoWhite

0


Best Answer

There is 4, 2 on each side behind the front wheels, You have a upper and lower ball joint. 1 on each controll arm.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How many ball joints are on a 1998 Chevy blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace ball joints on 98 Chevy blazer LT?

Remove the tire and wheel from your 1998 Chevrolet blazer. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.


When you turn your wheels to the right on your 1998 Chevy s10 blazer there is a creaking noise is it your shocks?

NO. More the likely the ball joints need to be greased.


How much does it cost to replace the ball joints on a 99 Chevy blazer?

$1200


How do you keep the front end of a 1998 Chevy Blazer from squeaking a week after it has been greased?

check suspension parts for excessive wear: i.e ball joints, tie rod ends, drag link, idler arm, springs, etc.


How do you replace the ball joints on a 1998 Monte Carlo Z34?

How do you replace the ball joints on a 1998 Monte Carlo Z34??


How much do Ball joints for a 2004 Chevy Malibu cost?

The 2004 Chevy Malibu ball joints will cost approximately $45 each. Replacing the ball joints will require approximately 3 hours of labor.


How do you put lower ball joints on 1994 Chevy S10 blazer. having problem getting it in straight. Am I sopose to put one end in first. How should it go in?

need to use a ball joint press.


How do you get the front wheel spindle off of a 1998 Chevy 4x4 blazer?

First you loosen the axle nut using a 34mm deep socket. then remove wheel. take brake caliper off then the upper and lower ball joints. then the spindle should come off.


How do you replace lower ball joints on a 2000 S10 blazer?

first you take it in then pay them to do them for you!!!!!!!!!!


Will you need a press for 97 blazer ball joint removal?

Im basing this answer off my 97 blazer ls 4wd. Both upper and lower ball joints are bolt on so u will need to remove the bolts and the ball joints should fall right off.


Can ball joints be tighten or be replaced on a 2002 Chevy Venture?

ball joints cannot be tightened. if they re worn and have play in them, they need to be replaced


How do I find out if there is a recall for ball joints for 1997 S-10 blazer?

Contact your local Chevy dealer with your vin number on hand and they'll be able to tell you of any recall(s) present for your vehicle.