To replace glow plugs on a Peugeot 405 turbo diesel, remove the connecting wire. Take off the 8 mm nut, followed by the 10 mm deep socket. Remove the old plugs and replace with new.
normally glow plugs are used on an IDi[ Indirect Injection] diesel engine. most peugeot 206 vehicles have an HDi engine[ Peugeot's nomenclature for Commonrail Direct injection]. hence there will be no glow plugs in those 206 vehicles. Some of the base model 206 from the first few years shipped with the non-HDi DW8 engine - which do have glow plugs. Check which model you have. If it's 1.9, then its the DW8. Else it is probably an HDi. Replace quickly if they start to fail.
where is the glow plugs on a fiat multipla
how to change glow plugs on1997 mercedes 300e
Depending on model, this engine may not have glow plugs. In engines with glow plugs, they are located next to the injectors on the top of the engine, under the plastic cover.
I had this problem and it was broken solder on the timing circuit board for the glow plugs
If you have the right tools its not too bad. To make life easy you need to remove the inlet manifold. Then remove the cables with 8mm spanner. Now you can get the plugs and they'll be tight. You really need to use a 12mm socket and you might need a bar. After you got them all out putting the new ones in is really easy.
FECK KNOW'S
Glow plugs nee changing!
They are under the rocker cover. You'll need to replace the rocker cover seal aswel if your replacing the glow plugs.
First, remove the wires. Then locate the nuts that hold the glowplugs in place and remove them. The glow plugs themselves can then be removed simply by unscrewing them. Then screw in the new glow plugs, replace the nuts and reconnect the wires.
First, remove the wires. Then locate the nuts that hold the glowplugs in place and remove them. The glow plugs themselves can then be removed simply by unscrewing them. Then screw in the new glow plugs, replace the nuts and reconnect the wires.