answersLogoWhite

0


Best Answer

You drive the cold roll pin out, BUT if planning on replacing slave cyl, replacing the master line and slave as a unit is recommended more often then not there will be a leak when replacing line.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does a holes come off a 1993 ford ranger slave cylinder?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix a slave cylinder in a 1993 ford ranger?

you just need to hone it out and replace parts with rebuild kit.


Where is the clutch slave cylinder on a 1993 ford ranger 4x4?

I believe that is inside the manual transmission bell housing


Where is the the bleed valve on a slave cylinder on a 1993 ford ranger?

The bleed valve is located on the drivers side of the bell housing.


Where is the Jeep Wrangler slave cylinder?

how to replace the slave cylinder on a 1993 jeep wrangler


How do you change internal slave cylinder to an external slave cylinder on a 1993 wrangler?

no none of the answers were my question


How do I attach the cable from master cylinder to the slave cylinder in a 1993 Ford Ranger?

the master and slave cylinder are a built in unit,there is no cable between them. there are piston'fluid connected. you can buy a rebuild kit for $9.00. But it is much better to buy a rebuilt master cylinder than try to rebuild it. Especially on ABS master cyclinders.


Is the clutch in the 1993 ford ranger a hydraulic clutch?

yes it is with the slave cylinder being inside the bee housing. the clutch master cylinder reservior is to the right facing the firewall. it requires brake fluid


Do you have to replace the master cylider if the slave cylinder has been replaced in a 1993 Saturn?

The Slave Cylinder and the Master Cylinder control totally different systems. The Slave has to do with the clutch, and the Master has to do with the brakes. They have nothing in common.


Does a 1993 2.3 Ford Ranger have a non-interference engine?

Yes , the 2.3 liter 4 cylinder in a 1993 Ford Ranger is a non-interference engine


How much does a 1993 Ford Ranger 4-cylinder gas tank hold in gallons?

I have a '93 Ford Explorer and it hold 19 gallons From the Chilton Ford Ranger guide: "1993 Ranger with standard wheelbase: 16.3 1993 Ranger with long wheelbase: 19.6"


Where is clutch slave cylinder 1993 rx7?

Bolted to the transmission underneath the car


How do you add brake fluid to the slave cylinder in a 1993 Escort?

You don't. You add it to the master cylinder and bleed the brakes.