Note:The drivebelt routing decal on the radiator shroud to help during drivebelt install * To replace the belt rotate the tensioner pulley clockwise to release belt tension * Remove the belt from the auxiliary components and slowly release the tensioner * Route the new belt over the various pulleys again rotating the tensioner to allow the belt to be installed then release the belt tensioner
do you have to lower or lift engine to take bolt off belt tentioner 2002 pontiac sunfire.
Highly doubtful.
Off the water pump
i wont to change my shifter but cant take off old one
Most cars have the diagram on a sticker some where in the engine bay if not go to your local parts store they can print off the belt diagram. If you have a new belt some have the diagram on the back of the packaging.
you did not turn the switch off they are not automatic
Most likely in the front? Might be covered by a plastic cover so you'll have to take that off to get at it.
i dont think that would make sense unless the timing belt is gone now if you had a 2.3 or 2.4 you would have to take the timing chain off any way
take off the one screw in the plastic behind the mirror adjuster and there is three nuts that hold the mirror on take them off
If you are putting new ones on just take a hammer and beat on the rotor until it comes loose.
there isn't one
Answerwater pump for a 98 sunfire is located with the timing belt can be a job. have to remove front of motor. enj. mount ect. More: Unless the 98 is much different from my 96, the water pump has nothing to do with the timing belt. Also, there is no need to remove an engine mount bolt.You should be able to loosen the belt tensioner enough to get the belt on and off the pump pulley.