0
I would suggest you remove the spark plugs and put about a half-teaspoon of Marvel Mystery Oil into each cylinder then crank the motor over a few times before putting in new plugs. Then give it some fresh gas and try to start it.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Chevy breretta has been sitting for over 3 years and now it won't start?
Starter, Gas, Battery, check these first...
How do you start a diesel engine that has been sitting for six years?
I have the same question but I'm 14 I'm a mechanic at our house. My truck is 1990 Chevy
What years does a 3.8 litter Chevy camaro v6 motor fit?
1995-2002
What motor company motor did dale earnheart win his races with?
Chevy. Most of his later years, his main sponsor was GM goodwrench.
How to start dodge caravan sport after sitting for 3 years?
place the key in ignition and turn
1970 Chevy motor fit in a 1997 Chevy truck?
yes, they use the same block design and block mounting though those years. you would just need motor mounts for a 97 as thickness and offset differ slightly.
You were just given a 1960 hydro swift with a 1960 80 hp mercury outboard you checked motor and noticed no plugs were in cylinders will that damage motor sitting 5 years you were told motor ran?
Motor should be fine as long as no water got into the cylinders
What years will fit a 1985 Chevy S-10 standard transmission?
1984 through 1987 as long as the motor is the same.
What do I need to do to safely start a 1980 VW Vanagon Westfalia after sitting in a garage for nine years?
Prayer, lots of prayer....
Can you put 1993 Chevy 350 heads on a 1977 350?
Should bolt right up... that motor didn't change for 40 years.
Where is the motor transmitting line located on a 1991 Chevy blazer motor Where the starter connects.?
I have worked on cars for 50 years and I truly can not imagine what you are referring to. It would be bestto describe your problem. That would be a great help.
Welbilt microwave MR95TW?
After 10 years of service my Welbilt microwave MR95tw has just conked out. the clock work fine. however, the motor does not engage. Is there anything I can do to get it started? When I hit "Start" I do hear a click but the motor does not start.
