answersLogoWhite

0


Best Answer

I have worked on jet pumps for years and never heard of shimming one. I can't even imagine where you would shim or why. Go to a good pump repair shop and ask.

User Avatar

Wiki User

βˆ™ 11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you shim a jet pump?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the water pump located on a 455 Oldsmobile engine that's in my jet boat?

the water comes from the jet pump that propels your jet boat forward. there is plate over the hole where the car type water pump would be. typically.


How long is jet pump hose 2002 Subaru Outback?

You will have to describe what a jet pump hose is. This terminology does not match with anything in my service manual.


Where is the 2000 Lincoln ls jet fuel pump located?

Fuel pump is in the gas tank. Fuel pump is in the gas tank. The jet pump is on the drivers side under the back seat, the fuel pump is on the passenger side under the back seat.


What is the symptoms of bad jet pump in a 2001 Lincoln ls?

The jet pump pumps gas from one side of the gas tank to the side with the fuel pump. When you first turn the key to the run position you should hear the jet pump for a few seconds. It's under the drivers side back seat.


Where is the steering nozzle on a PWC?

on the back of the jet pump


Can you replace a two pipe jet pump with a single pipe jet pump?

Yes you can if the water level from the inlet of the pump is less than 25 feet. That's the limit of a shallow well jet pump. It can lift water physically 25 feet vertically, no more. If the well casing diameter is three inch or larger you could also install a submersible pump.[url="http://www.pumpsandtanks.com/Pumps/jet_pumps.htm"]Jet Pumps[/url]


Can you convert a deep well jet pump to a shallow well jet pump by plugging the top three quarter inch opening and drawing water in through the bottom one and a quarter inch opening?

You can convert a deep well jet pump to a shallow well jet pump by plugging the top three quarter inch opening, and drawing water in through the bottom one and a quarter inch opening.


Which part of a PWC is dangerous to your hands feet and hair?

pump intake and the jet pump


What does shim mean in Hebrew?

"shim" is not a Hebrew word"


How does a jet pump work in a water well?

The most basic jet pump has a round pump chamber containing an impeller. The outlet to the well is large and the outlet to pressure tank is small. When the pump is primed and switched on it will suck water in and expel it at a higher rate. They are very susceptible to air leaks -every connection MUST be airtight.


Where can you find a Gould's Jo5N Jet pump or compatible replacement?

I


When was Mark Shim born?

Mark Shim was born in 1973.