Setting the Clock for Systems with SET ButtonPress SET. Within five seconds, press and hold the SEEK right arrow until the correct minute appears on the display. Press and hold the SEEK left arrow until the correct hour appears on the display. Setting the Clock for Systems with HR and MN ButtonsPress and hold HR until the correct hour appears on the display. Press and hold MN until the correct minute appears on the display. To display the clock with the ignition off, press RECALL or HR/MN and the time will be displayed for a few seconds. There is an initial two-second delay before the clock goes into the time-set mode.
Consult the owners manual.
You hold down the up and down buttons to the right of audio button
Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...
Check the fuses Should have 2 fuses for radio/clock one for radio and a separate one for the memory circuits
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.
have you tried turning off the radio and then press the set button then press the scan (up, dn) for hours then seek (up,dn) for minutes then press set again
how do you set the clock on a 2003 chevrolet trailblazer
How do you set the clock on a 2000 s-type jaguar?
'how do I set the clock on a 2001 mercury mountaineer'
How do you set the timing on a 2000 Chevy blazer (V6)
The cost of insurance for a Chevy Silverado pickup is not a set price. The cost is determined by the driver, the company, and the coverage needed.
press the set button. the word set will light up hold the seek button until the correct hour. then press and hold the scan button until correct minute appears and your done good luck.