You must use a 12 volt power supply(I.e battery charger) to "hot wire" wires going to motor. If possible, unplug the wires going in to motor and jump the terminals. If plug is not accessible you may need to carefully shave insulation off wire to expose a contact point. If the window doesn't move at first, remember its d/c. Switching the hot and ground will run the window in opposite directions.
You can manually roll up a power window by pulling on it. You can also remove the door panel and pull the window up.
you cannot manually roll up the window. I disconnected the harness and used 2 wires to jump power from the cargo light socket to the harness, one way is up the other is down by reversing them.
no. this window is locked on a track and connected to cables or gears. If you take everything apart and shim up the window only and still it does not come open easily.
You can but if the power window motor is bad it still won't roll up.
not really
If it is hard to roll up and has no broken regulator, you can spray silicone lubricante in thre tracks.
take the door panel off and disconect the wire assembly or window regulator that goes to the power window moter and manually pull the window up.
1999 Pontiac motana mini van driver window will roll down but will not roll up ??????
Yes
You can remove the door panel. And there are 3 star bolts that hold the power window motor. Once you remove the motor you can remove gear cable from motor and pull up the window by hand. That is the only way I know of. I had two motorcables brake on me.
you can by pass the switch, get wiring diagram and figuare out wich wires are for window motor you need rolled up, then remove switch and put power to wire that will make motor roll window up
Yes, you can remove the door panel and manually let the window down. When you do this, be careful not to break the window.