what all is it doing
i have a 99 mystique and my CPU went out and i had to find a new CPU but what my car did was try to start but it couldn't what i would do is take to a dealership and find out if it is the security system first off then i would go and replace any thing that is wrong with the vehicle such as CPU ignition coil knock senser and try again if it is still doing the same thing take it to the dealership and have them reprogram your vehicle it is not that expesive if you do it yourself and when Ford resets your security then it should start wright on up i did have a problem but that is how i fixed my car so you should try to the CPU's in the car could have just burnt up and that is what would stop it from starting because mine would turn over but not start well i hope this will help you in this little matter
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
If you feel around on the left side of the steering wheel on the bottom. Around where the e-brake is and the electrical unit you will feel a little switch, if you switch it that should do it. You might need to switch it a few times though
reset botton for the alarm
To reset an alarm system on a 2005 Honda Civic locate the brain. The brain should have a reset button located on it. Press it to reset the alarm.
in my past experience in alarms there should be a button hidden under the dash in your car The factory alarm is reset by turning the key in either front door or the liftgate.
how to reset hornet alarm,, cause my car can't start..alarm still active,,
my alarm system keep disable my car how do I reset or disable this alarm system
how do you reset the alarm system service light on a 2001 volvo s80
You can reset the Dodge Viper alarm system by removing the alarm system fuse. The location of the fuse can be found on the inside cover of the fuse box.
The remote control alarm system can be reset by entering the four digit pin number. Once the pin number is entered the alarm system will be reset.
Fix the problem with the air bag system and the alarm will reset itself.
A Brinks alarm system can be reset by first closing all doors and windows that have a sensor installed. Next, enter the three digit code on the keypad and then press cancel. The alarm will display an alarm cancelled message. Now press on and the system should be reset.