turn the ignition key to the on position (but do not start the vehicle) .Then push the trip odometer button a few times until the word oil appears on the screen. There will be a number next to the word oil. Hold the button in until the number 100 appears next to the word oil and then your good to go
Turn ignition switch on, press accelerator pedal to floor rapidly 3 times, start engine and light should go out. Do not press more then 3 times as then it will not reset.
Disconnect your battery. Yup..It's that simple.
remove the positive battery cable for about 20 min.
turn the key to the on position engine not running step on gas pedal to the floor three times and wait for light to flash and go out and its reset
You disconnect your battery and then reconnect your battery again.
The instructions on how to reset the brake maintenance light in a Chevrolet Malibu can be found in the owner manual. It can be viewed for free at Chevrolet's official website.
After repair, you reset with a scan tool.
The service engine soon light means there is regular scheduled maintenance due on the vehicle. Oil change, tire rotation, transmission service, etc. All this is spelled out in your owners manual. This is different than the Check Engine light which means the ECU has detected a problem with the emissions system. You have to manually reset the light according to the instructions in you owners manual. Disconnecting the battery will not reset the light.
Carefully!!! You will need to pressure bleed the system and it will require a scanner to reset the light.
Turn ignition to auxillary pump gas pedal three times turn ignition off then back on light should be reset. also if you call jiffy lube and tell them they did not reset light they will give you process to reset.
Reset the change oil light on Mazda 3
Why? Just reset it.