Remove the rock guard behind the bumper to allow access to the back of the lamp in the bumper. Unhook the wiring harness from the lamp, and it will be a quarter turn to remove. Common bulb, can purchase anywhere.
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
The SRI lamp may only be reset with the use of a DRBII scan tool, or equivalent. If this is not available, you will have to take the vehicle to a properly equipped shop for them to reset the lamp.
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
replace the burnt out bulb
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
this one is easy.....put the car in the on position(not running) and within 5 sec tap the gass pedel to the floor 3 times. the light should blink when taken(doesnt always on mine though). that should reset it! 93 fleetwood brougham.......d-body
I believe if you turn on the ignition key (do not crank engine) and depress the gas pedal three times it will reset itself.
The easiest way to reset the timing belt indicator lamp in your Toyota automobile is to remove the fuse for the indicator lamp. Keep the fuse out for approximately 30 seconds. Put the fuse back in and the indicator light should be off.
There is no reset for taillamp failure relay. If there is a fault the message will continue to be displayed www.lextechautomotivellc.com
With a scan tool.With a scan tool.
Its most likely to be a problem whit the wirering under the seat. check/mend it and then have your mechanic reset the cars computer.