0
Hi. It's easy to change, first drain down the fluid in the rad. take the big black fan cover off, 3 bolts on top and two down on each side. lift the top have out. then take the fan belt off. and remove the fan and pully there is 4 bolts that hold the fan on to the pully. there are 4 bolts on the water pump, two on each side of the pump.I think they are 1/2 or 9/16. It should take no more than 1 hour to do the job and this is for a first timer. Make sure you use new water pump gaskets and clean the block well before installing. Put everything back on in the reverse order. and top the rad back up again, before starting. PS make sure you disconnect the batter first before starting this job. Good Luck.
Add your answer:
Earn +20 pts
Picture of firing order 1992 Chevy Silverado?
wiring diagram for firing order for 1992 Chevy silverado
Blue book value of 1992 Chevy Silverado?
1992 Chevy 1500
Where is the location of the computer 1992 Chevy Silverado?
Behind the glovebox
What transmissions can go into a 1992 Chevy silverado 2500?
4L80
Does a 1992 Chevy Silverado have a catalytic converter?
When it was built, It had one.
How do you replace a CV joint on a 1992 Chevy pickup?
how do you replace a CV joint on a 1992 Chevy pickup?
Is it possible to just clean the solenoid on 1992 Chevy Silverado?
no its sealed
Is there a modulator valve on a 1992 Chevy Silverado 1500 5.7 liter?
No there is not.
Will a 1995 Chevy Silverado 5.7 liter motor fit in a 1992 Chevy Silverado?
Yes it will. Those 2 engines are the same. That would be a direct swop.
What size of transmission does a 1992 Chevy Silverado 4x2 automatic with a 305 have?
it is a 700r4
How do you Remove radio 1992 Chevy Silverado Can you find diagram?
try www.haynes.com
Where is the fusible link on a 1992 Chevy Silverado?
It is on the top of the firewall on the passenger side.
