Pull weather stripping out, off of the door jam on both sides. Dont take it all the way off, just enough so you can pull the rear deck trim off of both sides. The rear deck trim is held on by tabs so just pull out on it and it will pop off. Next, pull up on the front of the back seat (tug hard it will release) to release the two tabs and take out the bottom of the seat. You will see two nuts holding the seat belts on. Take those off and remove seat belts. Position your self in the middle of the seat facing the rear. Swing the bottom of the seat towards you to get it off the bolts and push up. The back of the seat hanges on 3 hooks at the top. Remove the back of the seat from the car. Now remove the lower trim that was on either side of the seat. Again, it is held on by some push in tabs so just pop it off. That will clear the way for the deck to slide out. You will see some push in tabs on the deck lid piece that the back of the seat was covering. Pop off those couple of tabs and pull the rear deck towards you. Now the speakers are visible and the rest should be common sense.
Which speakers are you trying to replace? Front or rear?
If the rear light of a Chrysler 300m does not turn on after replacing the bulb, a fuse may be blown. Replacing the fuse should fix it.
No you can just replace rear speakers.
go into the trunk and disconnect the wires and then pull the speakers out from the trunk and replace.
open your trunk and you will see the speakers take the screw out and pull your speakers out
depending on the year of your legacy you should be able to access the rear speakers from inside of your trunk.
Begin by removing the covers to your 1993 Geo rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the rear speakers. Reverse the process to install the new rear speakers.
good morning
no
To replace the rear speakers, you have to go in the trunk, look towards upper back section of the trunk and you will see the speakers. The speakers have two black hand-screws that can be unscrewed without tools. It is as simple as this.
In order to replace the speakers you have to flip down the rear seats and look at the screw ports and remove all the screws to remove the panel covering the speakers. The rest is self explanatory.
6x9 & 5x8 6