answersLogoWhite

0


Best Answer

Remove the radiator overflow resevoir(the clip will probably break, no big deal), jack the engine up a few inches with a floor jack, remove the bolts holding the motor mount on and replace.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the motor mount on a 2000 Ford Focus?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much does a motor mount cost for a Ford Focus?

Motor mount for a 2000 Ford Focus 2.0 SOHC costs right around 51.99. Plus 150.00 labor fee.


How much is labor to replace right side motor mount and left transmission mount on 2000 Buick Century 3.1?

it takes 5-6 hours to do all the motor mounts


Cost to replace motor mount 2000 Saturn SL2?

The cost to replace the motor mounts on a 2000 Saturn SL2 ranges from $500 to $1,000. The high costs are due to the labor intensive process of disconnecting and raising the engine assembly.


Where is the motor mount on a Mazda MPV?

how many motor mount has a mazda mpv 2000


Do need to remove the motor mount to replace belt on a 2000 Malibu?

yes you do. jack up under engine, put a block on jack so not to hurt engine, only put enough tension to re move left motor mount .then replace belt,put mount back on, lower jack, then check mount bolts fo tightness. 3.1 Chevy engine in 2000 Malibu!!


Where is the motor mount on a 2000 Chevy Tracker motor mount?

where its located the oil gage in a 2000 Chevy tracker mortor 2.0


How do you replace a blower motor resistor on a 2000 Ford Focus LX?

Take it to someone who knows how, unless you're a certified Ford mechanic.


Where is the starter on a 2000 stratus?

Front of the engine, behind the motor mount.Front of the engine, behind the motor mount.


How do you replace the steering column in a 2000 ford focus?

Program a new key and ignition to a 2000 ford focus


What would cause your 2000 Ford Focus sedan to vibrate?

My Focus vibrated when turning the wheel to the right and moving. Check the motor mount which is on the passenger side toward the rear. It has a round cap, about 4 inches wide. The motor mount will have a rubber cover under the cap, push on it, it should be filled with oil. If it is empty you need to change the mount. Jack the motor from the bottom with a floor jack a few inches, remove the bolts of the mount and reinstall a new one. 5 minute job, very easy.


How many motor mount in a Nissan Quest 2000?

3


What is the standard size motor in 2000 focus se?

2.0