You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.
Custom is lower end. Limited has more features.
The 1999 Buick LeSabre was a popular car for its time. The trunk release latch is located on the lower left hand side of the drivers seat.
You did not mention if it was the intake to the cylinder head bolts (1993 buick lesabre 96 in-lbs)..... or ..... the intake upper to lower bolts ( 1993 buick 132 in -lbs) but i hope you will know wich you are looking at since there is a large difference in torqe.
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
You can't service the lower ball joints by themselves. You must replace the entire lower control arm.
Piece of Cake!! remove serpentine belt (search here for answer how to), remove the lower of 2 bolts from the alternator, loosen the upper, rotate the alternator up, remove the bolt. Install is the reverse.
how to replace lower ball joints on 1995 4 wheel drive Nissan truck
If you can't find drain plug, just disconnect lower radiator hose.
You can replace just the ball joints on the lower control arms , but the upper ball joints come with a new control arm
Should be located at the rear lower section of the engine Remove the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove mounting bolts Remove starter
If you need to replace the lower ball joints, check your owners manual for instructions. The manual should show you the location and how to complete the repair.
it is on the passenger side of the engine compartment, and is part of the big silver accumilator.