I have a 1999 olds Cutlass GL but the bulb replacement should be the same 1. With the hood open and the engin off, pull the fastener out of the plastic splash shield covering the top of the headlamp assembly and remove it. 2. Carefully pull directly up on the two latches 3. Remove the lamp assembly from the vehicle by pulling forward. 4. Unclip the wiring harness and twist the bulb less than on-quarter of a turn counterclockwise and remove. Gently wiggle the bulb out of the socket. 5. Reconnect the wiring harness to the bulb or lamp assembly 6. Replace the lamp to its original position by carefully lining up the lamp to the mounting balls. 7. Press down on the tow latches. Replace the splash shield by pushing down on the retainer. Hope this helps
it the handle on the side of steering wheel chick it towards you or oppsite
its not the plug type its the sead beam type take one torqs bit nut loose form thr bulb and the light will come loose
With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.
you will probably have to replace the headlight switch.
try checking ur high-bea fuses and relays
replace the low beam headlight bulb
9006 for the low beam 9005 for the high beam
9006 for the low beam, 9005 for the high beam
It is on the upper left side of the steering column, low down, near the similar looking low-high beam switch. Both of those are manipulated by rods instead of being in the upper column.
9006 low beam, 9005 high beam
Low beam is a 9006 bulb, high beam is a 9005.
replace low beam bulb 2006 kia senoda