answersLogoWhite

0


Best Answer

Reach under the bumper cover , and you should feel the wires feel around once you have located the end of the socket twist it and the socket will fall down, then pull the bulb straight out, repeat with the other side

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the license plate bulbs on a 1992 Geo Prizm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the license plate bulb on a 2001 Geo Prizm?

The light is held by clips. You can remove the housing by using your fingers or a small screw driver. Once you have the housing out, you should be able to easily replace the light bulbs. The bulbs come in pairs and cost about 5 bucks.


How do you replace a license plate bulb on a 2005 grand prix?

Open your trunk the two inner bulbs are for your license plate twist and should pop right out


How do you replace the license plate bulbs on a 1998 Chevy Blazer?

push up and turn on the housing


How do you replace license plate bulb on 2008 Pontiac G8?

You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825


How do you replace the license plate bulbs on a Honda Pilot?

The clear covers for the license plate light bulbs have small arrows pointing in one direction. Simply push the cover to the direction of the arrows and the covers will slide off allowing for the old light bulbs to be replaced.


How do you replAce license plate bulbs on 1998 buick lesabre?

If you can not remove fasteners on outside, you may need to cut a section out of the inside of trunk to get your hand by the bulbs.


How do you replace one of the rear license plate bulbs on a 2002 Buick Regal?

OPEN THE TRUNK LID. JUST INSIDE THE LID BEHIND THE LICENSE BULB CASE ARE 2 PHILIP HEAD SCREWS THAT REMOVE THE BACKING PLATE. ONCE YOU REMOVE IT YOU CAN REPLACE BOTH LITTLE BULBS. THEN PUT THE PLATE AND SCREWS BACK IN YOUR READY TO GO.....


How do you replace the light bulb that shines light onto the license plate on the rear bumper of a 2003 Chevy blazer?

Remove the screws that hold the covers in place. Replace bulbs!


How do you replace License Plate Bulbs on 2004 Nissan Sentra?

There are two (2) lights directly above the license plate. Each light has two (2) screws. Remove these screws and the covers. Lights pop out with little effort. Replace bad bulbs with size 194 lights. These are approx $2 at walmart or an auto parts store. Once bulbs are replaced, reattach covers with the screws and you should be good to go.


How do you replace license plate light bulb on a 95 geo prizm?

there will be two. there will be a tab on the side of the black bracket, push the tab to the side the bracket will come out. then twist the light socket pull it it ant the pull out the bulb then but in the new. same for the other one. the bulbs are 1.74 for two at wal mart.


How do you change the license plate bulb on a 2001 ford escort?

On top of the license plate is a clear plastic lens with 2 screws in it. Take it off. Then a bulb slides into the holder, then replace the lens. There are 2 bulbs. One on each side.


How do you change the license plate bulbs on a 2000 Pontiac Sunfire?

in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.