You have to take the steering wheel off, not hard to do just go to your locall autoparts store buy the puller. once it's out off the way you will have to push down the damper plate and remove it...then you can take the screw out of the center of the hazzard button pull the switch out towards you and then disconnect the harness install in reverse
Lower the steering column.
The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike The flasher is built into the hazard switch. You need to pull the dash to replace the switch. It costs about $45 & is available through Chevy dealers. Mike
Usually not repairable, you will have to replace the complete multifunction switch.
how do you replace a CV joint on a 1992 Chevy pickup?
Take the old one out and put the new one in...
easiest option is to replace the steering column there all over junkyards with perfect switches in them
disassemble steering column,and replace signal arm ass'y
The Oil Pressure Switch is located on the driver's side top rear of the engine on your Chevy Pickup.
I think these had a small metal round knob somewhere by the key. The switch will be in the column if that's the case & you will have to pull the wheel.
how to replace an ignition switch for 2005 chevy equinox
how do replace a power steering hose on a Chevy c-1500 pickup truck
It is built into the multifunction switch which controls your signals,high beams,cruise,etc...have to replace entire unit.