depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.
2002 was the last model year that Oldsmobile Intrigues were produced. The Intrigue was the first Oldsmobile to end production in the process of phasing out the Oldsmobile brand. The last Intrigue rolled off the factory floor in June of 2002.
Bottom of the engine
pull out the fuse
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
crankshaft sensor b circuit
Check your battery cables. I had same issue
Fuel pump will not run.
how to replace crankshaft sensor on Corsa 1-2 2002 .Which parts require removing to replace unit
Unplug the whole light assembly from the bottom front of the car it just pops out to replace the turn signal bulb-same on the rear but you have to remove the trunk lining first.