Buy it at Walmart, Autozone, Pep Boys, or any number of places and they will install it for you. If you have a new battery you walked out with, perform the following in a well-ventilated area (avoid hydrogen gas buildup, which may cause the battery to explode (not fun)):
1. Disconnect the terminals and push aside.
2. Loosen the battery clamp in the base of the battery tray.
3. Remove the old battery, install the new.
4. Reattach the terminals, negative first. Be careful to avoid welding your wrench to some part of the vehicle.
you might need a thermastat. my 98 was doing the same thing. its easy and cheap to replace.
under the hood
5 1/4"
A spring loaded pully that keeps the serpentine belt tight
In the right kick panel. On my 98 Intrigue it's it the engine compartment in the black box connected to the air filter.
it has 4 sensors two before cat and two after
how do you replace a heater core in a 91 Oldsmobile 98
To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.
Most of the later GM washer pumps are located at the botoom of the washer fluid container. You will need to remove the tank to get access to the pump.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
Battery cable to starter?
check the starter, disconnect the negative side of the battery before removing the starter. once removed take it to autozone, advanced auto or orielly's and have them test it.