Shocks on a 2000 what? Some have shocks, some struts. If shocks, jack the car up and support it. Jack up on the rear wheel assembly enough to just take the pressure off of the shock and take it loose top and bottom. Rear wheel drive, the shock hold the rear end up when it is off of the ground. Front wheel drive may also depending on the make. Assume there is pressure down on the axle and jack it up before removing the old shock.
...since the question of how to replace rear shocks was for a 2000, and was in the "Lincoln Town Car" section, I assume the person asking was asking about a 2000 Lincoln Town Car. I have a 1995 Lincoln Town Car, that originally had an airbag rear suspension. I think the 2000's had airbag suspensions too. If so, is the trouble really with shocks or the air bags? When my airbags went out, I ended up swapping to a traditional coil spring & shocks setup, much cheaper than the ~$2000 I was quoted to fix the airbag problem...which MIGHT have been leaking airbags, MIGHT have been a computer control, MIGHT have been a bad compressor, or MIGHT have been a leak in the lines from the compressor at the front of the car to the air shocks at the rear. I had little faith in the shop that diagnosed it as a defective computer control unit ($1500 + labor), as I truly did not believe that unit had failed. Buying a rear suspension kit to replace the airbags, plus paying someone to put it in, ran me around $600.
Need to replace rear spark plugs
You take it to a shop.
You must remove the transmission are engine to replace the rear main seal.
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
remove upper intake plenum
check your local mechanic
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
You need to replace the rear wheel hub - bearing and speed sensor inclusive
Pay someone else to do it!
Remove the covers to your 2000 Chevy Malibu rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install your new rear speakers.
The entire bottom panel (5 bolts) has to be removed in order to replace the light.
Length of back brake line to replace. hole in it between front and back door